Imetec MAX POWER PARQUET - Manual (Page 10)

8
GB
ASSEMBLY [Fig. B]
ACCESSORIES [Fig. C]
During all assembly work, the appliance must be switched off and the power plug
disconnected from the power supply!
• Now select the combination brush (4) or the parquet brush (13) for the surface to be cleaned and insert
it into the vacuum connection (6) of the appliance.
Your appliance is equipped with the following accessories:
• Remove the fastening screw (2) of the hand grip (1) and pull it out.
• Connect the hand grip to the appliance body, making certain of a precise fit [Fig. B1].
• Insert the fastening screw (2) and tighten it clockwise [Fig. B2].
USE [Fig. D]
• Pull out the power cord (7) completely, but no farther than the red marking. The yellow cord marking is
located before the end of the cord with the red marking.
• Operation with an entirely or partially wound up cord can result in dangerous overheating!
• Insert the plug of the appliance into the power socket and switch the appliance on with the ON/OFF
switch (8) (position I).
• With the electronic power regulation (9), you can adjust the suction power of the appliance. Select the
following settings [Fig. D1]:
• Minimum or intermediate setting: for rugs and carpet
Maximum: for smooth floors and parquet
• After finishing your work, switch off the appliance with the ON/OFF switch (8) (position O) and pull the
plug out of the socket.
• Press the button (3B) to wind up the power cord [Fig. D2]. Hold the plug firmly during the automatic
winding to prevent it from whipping around.
Parquet brush (13): Special brush with soft bristles for cleaning of marble and parquet floors.
Combination brush for carpet / bare floor (4):
Set the combination brush to the floor type with the selector switch (5) [Fig. C1]:
- Selector switch (5) setting A (brush extended): for bare floors,
- Selector switch (5) setting B (brush retracted):
for rugs and carpet.