Imetec ECO E1 - Manual (Page 17)

EN
15
ATTENTION!
Let the filters dry for at least 24 hours after washing them. Do not reinstall
the filter if it is damp!
REPLACING THE HEPA FILTER (15E)
Ʒ Remove the dust collection system from the appliance [Fig. G1].
Ʒ Remove the Hepa filter (15E) from the support and replace it with a new filtering insert
[Fig. G4].
Ʒ Refit the appliance and insert the dust collection system before restarting it.
REPLACING THE OUTLET AIR FILTER (16)
Ʒ И»ЙЙК¾»¿ДК»ИВЕ¹БЕ¼К¾»ЕЛКВ»К¼¿ВК»И½И¿ВВ»ƺʾƻ·ДºИ»ГЕМ»К¾»ЕЛКВ»К¼¿ВК»ИƺʸʽƻƔ»Æ·¹»
it with a new one [Fig. G5].
Ʒ »¼¿КК¾»ЕЛКВ»К¼¿ВК»И½И¿ВВ»ƺʾƻ·ДºЙД·ЖК¾»¿ДК»ИВЕ¹Б¿ДЖВ·¹»Ɣ
STORING AND CARING FOR THE PRODUCT
¾»¹ЕГ¸¿Д»º¸ÈËɾƺʻƻ¹·Д¸»¾ЕЕБ»ºКЕК¾»·ЖЖВ¿·Д¹»¼ИЕГК¾»¾ЕИ¿РЕДК·Вƺʸʾƻ·Дº
М»ИК¿¹·ВƺʸʾƻЖ·ИБ¿Д½ЖЕЙ¿К¿ЕД¸»¼ЕИ»ЙКЕИ¿Д½¿Кƒƾ ¿½ƔʸƑʹƿƔ
TROUBLESHOOTING
PROBLEM SOLUTION
The appliance does
not turn on.
Ʒ ДЙЛИ»К¾·КК¾»ЖВЛ½¿Й¹ЕДД»¹К»ºКЕК¾»ЙЕ¹Б»КƔ
Ʒ ·Б»ЙЛИ»К¾»ƭ ¸ЛККЕД¾·Й¸»»ДЖИ»ЙЙ»º .
The appliance turns
off during use and
does not turn on
again.
Ʒ The vacuum cleaner is equipped with a protective
motor thermostat that shuts off the appliance in
the event of overheating! (caused by passageway
obstruction or clogged dust collection system).
Ʒ If triggered, switch the appliance off by pressing the
ON/OFF switch , disconnect the plug from the
ЙЕ¹Б»К·ДºВ»К¿К¹ЕЕВºÅÍĹЕГЖВ»К»ВП¼ЕИ·¼»Н¾ÅËÈÉƔ
Ʒ Remove any dust or obstructing objects before
restarting the appliance.
The vacuum cleaner
does not suction well.
Ʒ Electronic power control set to the minimum: increase
power to Medium or Max.
Ʒ The dust collection system (15) is full: clean the dust
compartment (15A).
Ʒ The filter is clogged: clean or replace the filter.