Imetec SILENT POWER COMPACT - Manual (Page 16)

EN
14
CLEANING THE COMBINATION BRUSH (12)
With the motor on and the bristles in position (A)
(extended bristles), rub the lower
part of the brush with your hand to remove dust and fluff that will be directly vacuumed.
CLEANING THE DUST COLLECTION SYSTEM (14)
When the suction power of the vacuum cleaner reduces, remove the collected dust from
the appliance.
ATTENTION! Empty the dust compartment (14A) and clean the filtering
system (14) after every use.
If the suction power of the vacuum cleaner does not improve after cleaning the dust
collection system, the filters are probably very dirty. In this case, replace them.
If replacing the Hepa filter (14E), it is recommended to also replace the other filtering
elements. Clean the dust collection system following the instructions below and paying
attention to the figures in the illustrative guide.
CLEANING THE DUST CONTAINER (14A)
• Press the flexible suction pipe fastening buttons (10A) and disconnect the flexible
suction pipe from the appliance (10).
• Open the dust collection system cover door (6) [Fig. G3].
• Remove the dust collection system (14) from the appliance [Fig. G4].
• Press the lower cover opening button (14B) to open the lower cover (14C) and empty
the container [Fig. G5].
CLEANING THE CYCLONE FILTER (14D)
• Remove the dust collection system (14) from the appliance [Fig. G4].
• Press the lower cover opening button (14B) to open the lower cover (14C).
• Rotate the cyclone filter (14D) anti-clockwise to disconnect from the dust container
(14A) [Fig. G6].
• If the cyclone filter (14D) is clogged with dust, wash it carefully with cold water. Take
care not to damage it and let it dry completely.
• Insert the cyclone filter (14D) in the dust container (14A).
• Rotate the cyclone filter (14D) clockwise until it is tightened securely [Fig. G6].
• Close the lower cover (14C).
• Insert the Hepa filter (14E) and the sponge filter (14F) in the dust collection system; it
will be positioned correctly when it snaps into place [Fig. G7].
• Insert the dust collection system into the appliance [Fig. G4].
CLEANING THE HEPA FILTER (14E) AND THE SPONGE FILTER (14F)
• Remove the dust collection system (14) from the appliance [Fig. G4].
• Remove the Hepa filter (14E) from the dust container (14A) [Fig. G7].
• Remove the sponge filter (14F).
• If the Hepa filter (14E) and the sponge filter (14F) are clogged with dust, wash them
carefully with cold water. Take care not to damage it and let it dry completely.
• Refit the Hepa filter (14E) and the sponge filter (14F) on the dust container (14A).
• Insert the dust collection system (14).
• Insert the dust collection system before restarting the appliance.
MI000956_corretto.indd 14 18/12/2012 17:36:11