Extron Electronics Universal Crimp Tool Die Installation - Manual

Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
800.633.9876 714.491.1500
FAX 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort, The Netherlands
+800.3987.6673 +31.33.453.4040
FAX +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Rd. #04-01
PM Industrial Bldg., Singapore 368363
+800.7339.8766 +65.6383.4400
FAX +65.6383.4664
Extron Electronics, Japan
Kyodo Building, 16 Ichibancho
Chiyoda-ku, Tokyo 102-0082
Japan
+81.3.3511.7655 FAX +81.3.3511.7656 www.extron.com
68-1491-01
Rev. A
10 07
Universal Crimp Tool Die
Installation Instructions
The Extron Universal Crimp Tool dies can be easily installed or replaced into an
Extron crimp tool handle as follows:
1 . Remove the top and bottom screws that hold the existing
dies in the crimp tool.
2 . Slide the top and bottom dies out of the crimp tool.
3 . Slide the replacement dies into the crimp tool.
N Pay careful attention to the orientation of the
dies. See the drawing below at right.
4 . Use the screws removed in step 1 to secure the
dies in place.
Remove Two
Screws
Bottom
Die
Insert into tool.
Front
Top
Die