beautypg.com

Extron Electronics FF 120T User Manual

Page 4

background image

4

68-1450-52

Rev.

C

10 12

Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West

Extron USA - East

+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX

+1.919.850.1001 FAX

Extron Europe

+800.3987.6673
(Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX

Extron Asia
+800.7339.8766
(Inside Asia Only)
+65.6383.4400
+65.6383.4664 FAX

Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX

Extron China
+4000.398766
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX

Extron Middle East
+971.4.2991800
+971.4.2991880 FAX

Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX

Extron India
1800.3070.3777
Inside India Only
+91.80.3055.3777
+91.80.3055.3737 FAX

© 2012 Extron Electronics All rights reserved.

www.extron.com

11.

Set the speaker on top of a T-rail making sure to hide the edges behind the grid rail.


















12.

If secondary support cables are being used, install them (see the illustration below).

ATTENTION:

DO NOT allow any slack in these support cables.

NOTE:

Observe all applicable building codes and local ordinances when installing the speaker.




















a.

Temporarily remove a ceiling tile adjacent to the speaker and set it aside.

b.

Connect a secondary support cable through the secondary attachment point, and attach it to one of the bendout tabs
located on either side of the speaker.

c.

Attach the other end of the cable to a sturdy part of the building (studs, roof struts, and so on).

d.

For additional secondary support cables repeat as needed (see the FF 120T User Guide for further details).

e.

Replace the ceiling tile removed in step

12a.

13.

Check all wiring before powering up the amplifier.

Extron

FF 120T

Ceiling

Speakers

Ceiling Tile

Ceiling Tile
Rails

T-rail (1)

2' by 4' Ceiling Tiles

Extron

FF 120T

Ceiling

Speakers

Ceiling Tile

Ceiling Tile
Rails

T-rail (1)

2' by 2' Ceiling Tiles

ATTENTION:

Repeated bending of the tab may cause it to break off.

Route the seconday support cable
through the secondary attachment point
and bendout tab.

Anchor this end to a
suitable secure point.

Secondary
Support Cable

Bendout Tab (2)