Hotpoint Ariston Diamond FD 61.1 (SL)-HA - Manual (Page 17)

17
GB
Analogue programmer
Setting the time
Press the PROGRAMMER knob and turn it
anticlockwise to set the correct time.
! The clock can only be set if the oven is connected to
the mains. In case of a power failure, the
PROGRAMMER will stop: the correct time will have to
be reset.
Starting the oven
1. Turn the PROGRAMMER knob anticlockwise until
the “” symbol is displayed.
2. Pull the PROGRAMMER knob and turn it
anticlockwise until the knob marker lines up with the
current time. A click will indicate the end of the
programming phase.
3. Select the desired cooking mode using the
SELECTOR knob.
4. To turn the oven off, set the SELECTOR knob back
to the “0” position.
Programming your cooking
Programming instant cooking time
1. Turn the PROGRAMMER knob anticlockwise until
the desired cooking time is displayed.
2. Pull the PROGRAMMER knob and turn it
anticlockwise until the knob marker lines up with the
current time. A click will indicate the end of the
programming phase.
3. Select the desired cooking mode using the
SELECTOR knob. The oven comes on immediately and
stays on for the entire duration of the set cooking time.
4. When the selected time has elapsed, a buzzer will
sound and the oven will turn off.
• For example: it is 9:00 a.m. and a time of 1 hour and
15 minutes is programmed. The programme stops
automatically at 10:15 a.m.
Programming a delayed cooking time
1. Turn the PROGRAMMER knob anticlockwise until
the desired cooking time is displayed.
2. Pull the PROGRAMMER knob and turn it
anticlockwise until the knob marker lines up with the
desired cooking start time.
3. Select the desired cooking mode using the
SELECTOR knob. The oven will come on at the set
cooking start time and will stay on for the entire
duration of the set cooking time.
4. When the selected time has elapsed, a buzzer will
sound and the oven will turn off.
• For example: it is 9:00 a.m. and a time of 1 hour and
15 minutes is programmed and the start time is set
to 11:00. The programme starts automatically at
11:00 and ends at 12:15.
! To cancel programming, turn the PROGRAMMER
knob anticlockwise until the symbol “” is displayed.