Xylem XL-BASIC Programming Guide - Manual (Page 4)

23-4 XL-BASIC Programming Guide
XL™ SERIES
Read Only Variables:
Variable Type Description
Date Read Only The date is returned in the format YYMMDD.0000
Time Read Only The time is returned in the format HHMMSS.0000
seconds Read Only Return the current seconds in the format SS.0000
minutes Read Only Return the current minutes in the format MM.0000
hours Read Only Return the current hours in the format HH.0000
day Read Only Return the current day in the format DD.0000
month Read Only Return the current month in the format MM.0000
year Read Only Return the current year in the format YY.0000
Batt Read Only The current battery voltage reading is returned
minbatt Read Only Return the minimum battery voltage measured since option was reset.
maxbatt Read Only Return the maximum battery voltage measured since option was reset.
tankpsi Read Only Return H-355 tank PSI if an H-355 is connected.
linepsi Read Only Return H-355 line PSI if an H-355 is connected.
purgepsi Read Only Returns H-355 purge PSI setting.
purgedur Read Only Returns H-355 purge duration setting.
bubrate Read Only Returns H-355 bubble rate setting.
Purge Read Only Returns H-355 purge status, 0 = bubbler communication error.
1 = request for purge accepted.
2 = already purging.
Resets Read Only Returns the number of times the system has reset.
LogvalX Read Only Returns the value associated to a log column when the column is setup to
perform some function on the data like calculating the average, etc. The
‘X’ is the log column 01 to 25.
Note: The read only variables may be read but should not be written. Trying to set or write one
of these variables to some value will have no affect, and the program will continue on
under normal operation. If one of these variables is set to some value and then read
again, the value returned will not be the value set by the program but will be a value
based on the function behind the variable.