Xylem O&M Mini F Series Variable Speed - Manual

Operating and Maintenance Instructions
Declaration of conformity
Lowara pumps UK declare that the Mini F Booster set conforms to the requirements of the Machinery Safety
Directive 98/37/EEC.
Conforming to the UK Health & Safety Requirements
S.I. 1992 No 3073 S.I. 1994 No 2063
Water supply (Water fittings) regulations 1999
Simple pressure vessel directive 87/404/EEC
Signed: Position: Engineering manager Date: 27-02-2012 Revision
Clive Willmot t
Introduction
This leaflet contains information to enable the safe installation and operation of the products mentioned.
The following instructions must be read and understood by all persons responsible for the installation,
operation and maintenance of this product.
Warning Symbols
Safety instructions where noncompliance would affect safety.
Safety instruction where electrical hazard is involved.
Safety instruction where noncompliance could cause damage to the equipment.
Instruction for safe us
This product has been designed for boosting cold water in potable water installations to the
operating conditions shown.
This product should not be installed until this leaflet has been studied carefully and understood.
Handling, transportation and installation of this equipment should only take place with the proper
use of lifting equipment. This product must be stored in a frost-free dry environment.
Noise Emission
This equipment operates at a noise level lower than 70dBA.
Operating limits
Fluid temperature 0°C to 40°C
Ambient temperature 0°C to 40°C
Operating pressure Max 5Bar.
Protection class. Motor & Electrical panel IP55
Mini F 1-2 Pump Cold Water
Booster Sets Fixed Speed
1
mini f booster set o and m instructions:Layout 1 09/05/2012 15:37 Page 1