Xylem IM192R00 FloStandard SIMPLEX PUMP CONTROL PANEL - Manual (Page 4)

ITT
CENTRIPRO
Commercial Water Systems
All electrical work must be per-
formed by a qualified technician.
Always follow the National Electrical Code (NEC),
or the Canadian Electrical Code, as well as all
local, state and provincial codes. Code questions
should be directed to your local electrical inspec-
tor. Failure to follow electrical codes and OSHA
safety standards may result in personal injury or
equipment damage. Failure to follow manufactur-
er’s installation instructions may result in electrical
shock, fire hazard, personal injury or death, dam-
aged equipment, provide unsatisfactory perfor-
mance, and may void manufacturer’s warranty.
See specific pump and motor name-
plates for all agency Listings.
Check motor nameplate and Flo-
Standard nameplate for all electri-
cal ratings.
The FloStandard fixed-speed pump
panel may have safety devices that
will stop the motor in the event of electrical,
mechanical load or external faults. This does not
remove power to the panel.
The FloStandard may have an auto
reset feature in the event of faults,
which can result in the pump motor restarting
unexpectedly. You must remove all main power to
the pump and motor before attempting a repair.
PRE-INsTallaTION ChECks
Open all cartons and inspect for
shipping damage. Report any dam-
age to you supplier or shipping carrier immedi-
ately.
Verify that all equipment is the correct voltage and
phase. Warranty does not cover damage caused
by connecting pumps and controls to an incorrect
power source (voltage/phase supply).
Record the model numbers and serial numbers
from the pumps and control panel on the front of
this instruction manual for future reference. Give
it to the owner or place it in the plastic protective
pocket inside the panel cabinet when finished with
the installation.
saFETY INsTRUCTIONs
TO AVOID SERIOUS OR FATAL PERSONAL
INJURY OR MAJOR PROPERTY DAMAGE,
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS IN MANUAL AND ON
PUMP.
THIS MANUAL IS INTENDED TO ASSIST
IN THE INSTALLATION AND OPERATION
OF THIS UNIT AND MUST BE KEPT WITH
THE PUMP.
This is a SAFETY AlERT
SYMbOl. When you see this
symbol on the pump or in the
manual, look for one of the
following signal words and
be alert to the potential for
personal injury or property
damage.
Warns of hazards that WIll
cause serious personal injury,
death or major property
damage.
Warns of hazards that CAN
cause serious personal injury,
death or major property
damage.
Warns of hazards that CAN
cause personal injury or
property damage.
NOTICE: INdICATES SpECIAl
INSTRuCTIONS WHICH ARE
VERY IMpORTANT ANd MuST bE
FOllOWEd.
THOROugHlY REVIEW All
INSTRuCTIONS ANd WARNINgS
pRIOR TO pERFORMINg ANY WORK
ON THIS puMp.
MAINTAIN All SAFETY dECAlS.
daNgER
WARNING
CAUTION
WARNING
WARNING
WARNING
daNgER
daNgER
WARNING