Acer S1212 - Manual (Page 37)

27
English
About Acer SmartPen Setting
Note 1: Preparations
1. Connect the projector and your computer with a USB cable and VGA cable.
2. Turn on your projector and make sure it is displaying the computer’s
image.
3. Plug the PB dongle to the PB dongle slot on the side of the projector.
4. Enable the pen by selecting "On" in the Setting > SmartPen > Pen Function
menu. The pen’s link light starts to blink.
5. Point the pen at the screen to point, click, and drag.
Note 2: Overview of the Acer SmartPen
Note 3: Charging the battery
1. To charge the battery, open the flap on the back of the pen to expose the
USB connector.
2. Take a USB cable, and connect the smaller end to the pen and the larger
end to a computer. Make sure the computer is powered on.
3. The battery light stays on while the battery is charging. When charging is
finished, the battery light is off. You can disconnect the USB cable or keep
it connected.
Nib
Power switch
Right mouse button
Left mouse button
Link light
USB connector
Information key