beautypg.com

Start-up and use, Measuring out the detergent, Starting the dishwasher – Hotpoint Ariston PFK 724X User Manual

Page 18

background image

EN

18

Start-up and use

Measuring out the detergent

A good wash result also depends on the correct
amount of detergent being used; exceeding the stated
amount does not result in a more effective wash and
increases environmental pollution.

Only use detergent which has been

specifically designed for dishwashers.
DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle

has ended.

The use of tablets is only recommended for

models which offer the MULTI-FUNCTIONAL

TABLETS option.

To achieve the best results from each washing and

drying cycle, powder detergent, rinse aid liquid and salt
should be used.

Compartment A: Washing detergent
Compartment B: Pre-wash detergent

1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the Table of wash
cycles:
• For powder detergent use
compartments A and B.
• For detergent in tablet form:
when the cycle requires 1 tablet,

place it in compartment A and close the cover; when it
requires 2, place the second tablet at the bottom of the
appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.

A

B

D

C

*

Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.

2. Premere il tasto ON-OFF: si sente un breve bip, tutte le spie

e il display si illuminano per alcuni secondi.

2. Press the ON/OFF button: you will hear a short beep; all the

indicator lights and the display will light up for a few seconds.

3. Open the door and pour in a suitable amount of detergent

(see below).

4. Load the racks (see Loading the racks) and shut the door.

5. Select the wash cycle by turning the WASH CYCLE SELECT

knob in a clockwise direction: align the notch on the knob with

the number or symbol representing the desired wash cycle.

The START/PAUSE indicator light will flash.
6. Select the wash options

*

(see adjacent information).

7. Start the cycle by pressing the START button; the indicator

light up, and remain lit in a fixed manner. The indicator light

corresponding to the washing phase will switch on, signalling

that the wash cycle has begun and the time remaining until the

end of the cycle is displayed.

8. At the end of the wash cycle the END indicator light will

switch on (fixed light). Switch off the appliance by pressing the

ON/OFF button, shut off the water valve and unplug the

appliance from the electricity socket.

9. Wait for a few minutes before removing the crockery, in

order to avoid burns. Unload the racks, beginning with the
lower level.

- The machine will switch off automatically

during certain periods of inactivity, in order to

minimise electricity consumption.

AUTO WASH CYCLES

*

: this model of dishwasher is

equipped with a special sensor which can be used to assess

the level of soiling and automatically select the most efficient

and economic wash cycle accordingly.

The duration of the auto wash cycles may vary due to the

operation of the sensor.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: once the wash cycle has started, switch off

the machine by pressing and holding the ON/OFF/Reset

button. Switch it back on using the same button and select the
desired wash cycle and options.

Adding extra crockery

Press the Start/Pause button (the corresponding indicator light

will flash). Open the door, taking care to avoid the escaping

steam, and place the crockery inside the appliance. Press the

Start/Pause button (fixed light): the cycle will restart after a
prolonged beep is emitted.

If the Start/Pause button is pressed so as to pause the

machine, the wash cycle or the Delayed Start function (if
selected) is interrupted.
At this stage it is not possible to change the wash cycle.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or once

the electricity supply is restored.

This manual is related to the following products: