AEG S72300DSX0 - Manual (Page 22)

6.5 Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover
4. Replace the old lamp with a new
one. Use only lamps for household
appliances. The lamp cover shows
the maximum power of the lamp.
5. Install again the lamp cover.
6. Connect the mains plug to the mains
socket.
The type of light bulb or halogen
lamp used for this appliance, is
only for household appliances.
Do not use it for house lightning.
7. TROUBLESHOOTING
WARNING!
Disconnect the mains plug from
the mains socket before you do
the check.
For problems that are not in the
table, contact the Service.
Problem Possible solution
The appliance makes
noise during operation. Some sounds are normal when the appliance is
operating. Refer to the leaflet supplied with the
appliance.
The appliance does not
operate. Make sure that the appliance is activated.
Make sure that the mains plug is connected to the
mains socket.
Do a check and see if there is voltage. Connect a
different appliance to the same mains socket. To
repair a mains socket, contact a qualified electri-
cian.
The lamp does not come
on. Close and open the door to make sure that the
lamp is not in standby.
The lamp is defective. Replace the lamp.
The compressor operates
continuously. Set the temperature knob at a lower position.
Make sure that the appliance door is closed.
22 www.aeg.com