Camp Chef MS2HP - Manual (Page 5)

5. If “growing” bubbles appear, there is a
leak. Close LP tank valve immediately and
retighten connections. If leaks cannot
be stopped, do not try to repair. Call for
replacement parts. Order new parts by
giving the serial number, model number
and name of items needed to the Service
Center at 1-435-752-3922.
6. Always close LP tank valve after performing
tank leak test by turning hand wheel
clockwise.
Setup instructions:
• Place stove on a flat, level, sturdy surface.
• Open the lid and attach the windscreens to
the tabs on the inside of the lid. Snap into
place as shown.
• Make sure the burners are in the off
position.
• Push regulator assembly firmly into
stove. Tighten nut securely.
• Screw propane cylinder into the regulator.
Lighting Stove instructions:
1. Turn burner valve on and press the red
ignitor button until the burner lights.
2. If ignition does not occur in 5 seconds, turn
the burner control(s) off, wait 5 minutes,
and repeat lighting procedure. If built-in
ignitor will not light follow the preceding
steps and hold a lit long igniter or match
next to the burner when opening the
control valve.
3. Adjust the flame to the desired height.
Flame should be compact and blue in color.
4. Avoid getting dirt in the valves, regulator,
and burners.
5. To shut burner off, turn the valve to off.
(Clockwise)
If the flame is accidentally extinguished, turn
the appliance valves OFF and WAIT 5 minutes
before attempting to ignite.
Burner Flame Check
• Light burner; rotate knob(s) from HIGH to
LOW. You should see a smaller flame in
LOW position than seen on HIGH. Always
check flame prior to each use. A good flame
should be blue with minimal yellow tip.
Some yellow tips on flames are acceptable as
long as no carbon or soot deposits appear.
turning Lp Cooker off
• Turn all knobs to OFF position. Turn LP tank
OFF by turning hand-wheel clockwise to a
full stop.
hose Check
• Before each use, check to
see if hoses are cut or worn. Replace
damaged hose assembly before using
appliance. Use only valve/ hose / regulator
specified by manufacturer. See product sheet
for hose & regulator information.
Cleaning the Burner
NOTE: Spiders and small insects can spin
webs and build nests inside the burner. This
especially occurs in late summer and fall
before frost when spiders are most active.
These nests can obstruct gas flow and cause
a fire in and around the burner and orifice.
Such a fire can cause operator injury and
serious damage to the appliance. To help
prevent a blockage and ensure full heat
output, clean and inspect burner tube often
(once or twice a month). NOTE: Water or air
pressure will not normally clear a spider web.
Cleaning and Maintenance
Correct care and maintenance will keep
your appliance operating smoothly. Clean
regularly as determined by the amount of
use. NOTE: Clean the entire appliance each
year and tighten all hardware on a regular
basis (1-2 times a year or more depending
on usage). Cleaning should be done where
detergents won’t harm patio, lawn, or the
like. Keep appliance area clear and free
from combustible materials, gasoline and
other flammable vapors and liquids. Keep
the ventilation opening(s) of the cylinder
enclosure free and clear from debris.
Suggested Cleaning Materials
• Mild dish washing liquid detergent
• Wire brush
• Nylon cleaning pad
• Hot water
• Paper clip
• Soft brass bristled brush
Component Cleaning:
• Burner should be wiped clean. Hot soapy
water and a soft bristle brush can be used
to clean the burner surfaces. Clean clogged
gas port holes with an opened paper clip.
Replace corroded or damaged burners that
would emit excess gas.
• COOKING SURFACES, POTS AND PANS: Clean
the cooking surface with soapy water and a
nylon cleaning pad.
• After appliance has cooled, wipe areas
where paint and finish have burned off to
minimize rusting.
WARNING
• Do not use appliance until leak
checked.
• If you cannot stop a gas leak,
immediately close LP tank valve
and call LP gas supplier or your
fire department!
WARNING
• Do not put hands or any other body
parts over the burner during lighting
or when in use to prevent burns.
CAUTION
All cleaning and maintenance should
only be done when the appliance is
cool and with the fuel supply turned
off at the LP cylinder. DO NOT clean
any part in a self-cleaning oven. The
extreme heat will damage the finish.
To activate warranty, register on-line at:
www.CampChef.com
The manufacturer warrants stove compo-
nents (except paint and finish) to be free
from defect in materials and workmanship
for 1 year from the date of purchase. All ac-
cessories (included with stove or purchased
separately) are warranted from defect in
materials and workmanship for 90 days
from the original purchasing date. Within
these periods, the manufacturer will replace
or repair defective parts deemed unusable
from its original intent by making available
the parts thereof FOB Logan, UT 84321
Product paint and finish is not warranted.
The exterior finish of the product will wear
down over time.
Clean the unit after each use to maintain
the finish and prolong the life of your prod-
uct. Wipe away all grease and ashes. Keep
metal products free of moisture, salts, acids
and harsh fluctuations in temperatures.
Warranty does not cover normal wear of
parts or damage caused by misuse, abuse,
overheating and alteration. Repairs or
alterations made by anyone other than
Camp Chef are not covered in this War-
ranty. Manufacturer will not be held liable
for any losses due to neglectful operation.
Furthermore, this Warranty does not cover
damaged caused by natural disasters such
as earthquakes, hurricanes, tornadoes,
floods, lightning, fires, etc.
Upon the expiration of this warranty all
such liability will terminate. No other
warranties are expressed or implied.
Keep all original sales receipts. Proof of
purchase is required to obtain Warranty
services. Prior written approval and a
Return Authorization Number must be
obtained and accepted for repair or
replacement only. Returns must be shipped
prepaid. Collect shipment or shipments
without a Return Authorization Number
will not be accepted.
To obtain Warranty services call
1.800.650.2433.
*Warranty applies to the contiguous US
states only.
LiMited WarrantY