Camp Chef MS2 - Manual (Page 3)

still a leak, remove the cylinder and
contact the manufacturer for service
or repair.
4. The regulator uses a threaded fitting
to attach to the stove. It is necessary
to hold the stove to make sure the
fitting is seated. Align the regulator
to the fuel tube on the rear of the
stove and push on. Screw on the
outer threaded sleeve in a clockwise
direction until tight.
5. Never operate stove with propane
cylinder in an inverted position.
Setup Using Optional Hose And
Refillable Cylinder
1. Make sure burner valves are off.
2. Attach Camp Chef Model HRDSP
hose to regulator & regulator to stove
(as shown).
3. Attach hose to cylinder.
4. Open cylinder valve.
5. Perform leak check on hose to
regulator, and hose to cylinder
connections with soapy water.
Bubbles indicate a leak. Check that
the connection is not cross-threaded
and that it is tight. Perform another
leak check. If there is still a leak,
remove the cylinder and contact the
manufacturer for service and repair.
6. Turn off fuel at the cylinder and
disconnect both ends of the hose
when not in use.
Dismantling Hose And
Refillable Cylinder
1. Before dismantling high pressure
hose, be sure gas pressure in hose is
eliminated.
2. Ignite stove and turn off gas valve on
cylinder.
3. Allow flame to self-extinguish.
4. When flame is out, close valves on
the appliance.
5. Remove hose.
• Use appliance only with LP (propane)
1. DO NOT leave this appliance unat-
tended while in use. The user must
remain in the immediate area of
the product and have a clear view
of the product at all times during
operation.
2. Keep children and pets away from
burner at all times.
3. The use of alcohol, prescription or
non-prescription drugs may impair
your ability to properly assemble or
safely operate this appliance.
4. For OUTDOOR use only. Do
NOT use in a building, garage
or any other enclosed area. Do
NOT use in or on recreational
vehicles or boats. NEVER use this
appliance as a heater.
5. Do not operate appliance under
ANY overhead construction.
Keep a minimum clearance of
1 foot (0.3 m) from the sides,
front and back of appliance to
ANY construction. Keep the area
clear of all combustible material
and flammable liquids, including
wood, dry plants and grass, brush,
paper, and canvas. Never use this
appliance within 25 ft. (7.5 m) of
any flammable liquid.
6. Use ONLY on a level, stable
surface.
7. DO NOT place an empty cooking
vessel on burner while in operation.
Use caution when placing anything
in the cooking vessel while burner
is in operation.
8. Do NOT move the appliance when
in use. Allow unit to cool to 115°F
(45°C) before moving or storing.
9. This appliance will be hot during
and after use. Use insulated oven
mitts or gloves for protection
from hot surfaces or splatter from
cooking liquids.
10. In case there is a fire, call the
local fire department or dial
911. Stay clear from flames.
Do not attempt to extinguish an
oil or grease fire with water.
11. Do not obstruct the flow of com-
bustion and ventilation air.
NOTE: This appliance is set to use 16.4 oz. disposable
propane cylinders. Use only cylinders marked propane.
Disposable propane cylinders must be disconnected from
the stove when it is in storage.
Refillable Bulk LP-Gas Tanks with a maximum capacity
of 20 pounds may also be used with an optional bulk tank
adapter hose. (Use Camp Chef Model HRDSP to connect
to the bulk tank.) Refillable propane gas cylinders must be
turned off at the LP-Gas supply cylinder when the stove
is not in use.
The LP-gas cylinder(s) used with this stove must be
constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S. Department
of Transportation or Transport Canada, CAN/CSA B339.
Setup Using Disposable Bottle
1. Make sure burner valves are off.
2. Remove plastic cap from top of
propane cylinder. Save cap for use in
storing. Screw propane cylinder into
regulator. Be careful not to cross
thread. Hand Tighten only.
3. Check the connection between the
cylinder and the regulator with
soapy water. Bubbles indicate a leak.
Check that the connection is not
cross-threaded and that it is tight.
Perform another leak check. If there is
LEAK CHECK
REGULATOR
& HOSE
Leak Test
0809-MS2-Instructions.indd 4-5 8/12/09 9:30:49 AM