Camp Chef CS14 - Manual (Page 4)

6. Installing the damper - There are 5 sections to the chimney. Each gets larger in
diameter as they go up. The first section has two holes for installing the damper. First
remove the wire rod from the damper. Hold the damper down inside the chimney and
insert the rod first through the hole in the pipe, through the damper, and out the hole
on the opposite side of the pipe. Take note that when damper rod handle is horizontal
the damper is closed. When the damper rod handle is vertical the damper is open.
7. Installing the chimney pipe - Starting with the largest pipe first install the spark
arrestor over the top of the pipe. Then install this pipe into the next and so on until all
five pipes are assembled together. (If using the stove in windy conditions sheet metal
screws should be used to fasten the pipes together.) Once the chimney is assembled
lift the chimney up through the stove jack in the tent and then install into the top of the
stove. (Note: Depending on stove jack size some chimney sections may need to be
installed down through the stove jack from the outside of the tent.)
(Warning: The stove pipe should extend a minimum of 6” above the ridge of the tent.)