C2G 35555 TRULINK 4-PORT VGA AND USB 2.0 KVM User Manual

Page 8

EVICE

NSTALLATION

Note: Be sure that all computers and the monitor are turned
off before making connections to the KVM.
Step 1: Plug the power adapter into the KVM and then into an
AC wall outlet.
Step 2: Connect the USB cable Type-A end to an available
USB port on your computer, and the USB cable Type-B end to
the any available port on the KVM.
Step 3: Connect the VGA male-to-female cable between the
video output of your computer and video input port that
corresponds to the USB port you selected in step 2.

Repeat steps 1-3 for any other computers you are connecting
(up to four computers can be connected at the same time).

Step 4: Connect your monitor, keyboard, and mouse to the
appropriate ports on the KVM.
Step 5: Power on the computers and the monitor

If you are using a USB keyboard and/or mouse on the
KVM’s hub ports, then you must enable the Hub-Switch
function. See the Device Operation section on page 11 for
instructions.

Powering Up the Systems
For best performance from your display, make sure to select a
port first, and let that PC completely boot before switching to
another port. This is especially important for Linux and Sun
users.

Hot Plugging
The KVM switch supports USB plug & play technology. USB
devices can be added and removed to the built-in hub at any
time without the need to shutdown the computers. To avoid
problems, please do not plug/unplug devices during a PC’s
boot cycle or while switching KVM ports.

NSTALLATION DU PERIPHERIQUE

NSTALACIÓN DEL DISPOSITIVO