AVSL 154.012 WSL-Q7 - Manual (Page 2)

154.012UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the WSL-Q7 wireless quad colour PAR light as part of your effect
lighting setup. This unit has been designed to provide wire-free colour effects for stage shows,
special events and architecture. Please read the following instructions for best results.
Unpacking
Your WSL-Q7 should reach you in good condition, supplied with appropriate mains lead(s),
mounting bracket and RF antenna. If there is any damage or items missing from the
packaging, contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose any components to rain or moisture.
If liquids are spilled on the housing, disconnect mains, allow unit to dry out and have the unit
checked by qualified personnel before further use.
No user serviceable parts inside – do not open – refer all servicing to qualified personnel.
Safety
 Check for correct voltage and condition of IEC lead before connecting to power outlet
 Ensure DMX leads are in good condition with no short connections or damaged plugs
Placement
 The WSL-Q7 may be placed free-standing by using the double bracket as a bipod
 If mounted at height, use the double bracket and attach a drop cable for safety
 If the unit is mounted at height, a drop cable should be attached for safety
 Ensure adequate air-flow to the side vents for cooling
 Ensure adequate access to controls and connections and best line of sight for antennas
Cleaning
 Use a soft dry or slightly damp to clean the cabinet and lenses. Do not use solvents
Charging the battery
The WSL-Q7 can be operated from its own internal rechargeable Lithium ion battery.
The charge status can be checked by pressing the BATTERY CHECK button on the rear panel.
When this button is pressed, the percentage of full charge is displayed by a row of 4 LEDs.
If the battery needs charging, connect to the mains with the supplied IEC lead and the battery
will re-charge the battery from the mains. Switching power on will operate the WSL-Q7 from
the internal battery or from mains if connected. Switch power off when not in use or when re-
charging the battery.