AVSL 160.565 SW-2 SNOW MACHINE User Manual
Page 4
160.565UK User Manual
Make sure that the remote control rocker switch (11) is set to the “off” position at startup
Switch the mains power on (4) at the rear of the unit And the power indicator (10) will light
Set the output control (8) to the lowest setting and switch the rocker switch on
The snow effect indicator (9) will light to show that the fan is active
Adjust the output control to the required density of snow pumped into the nozzle when active
Switch the rocker switch off to stop the fan and thus stop the effect
DMX operation
For DMX operation, a single channel controls both the fan and snow output pump.
Connect DMX input from a controller or prior device to the XLRM connector (2) on the rear panel
Connect further DMX devices from the XLRM connector (3) on the rear panel
Set the DMX address (single channel) using the DIP switches (1) in binary format as shown below
DMX control values operate the snow machine as follows.
Value
Fan
Fluid pump
0 - 5
Fan off
and no snow output
6 - 255
Fan on
and snow output
When in use for long periods, periodically check the fluid level indicator and refill if necessary.
Check that the foam produced does not cause a slip hazard on the floor surface and clean if necessary.
Switch of mains power when not in use. Disconnect from mains before moving or storage.
Specifications
Power supply
220-240Vac, 50/60Hz (IEC)
Tank capacity
5 litre
Power
1200W
Volume per minute
50m³
Remote control
Wired remote (on/off & output volume)
DMX channels
1 channel (fan on/off & output 1 - 100%)
Dimensions
320 x 300 x 525mm
Weight
7.6kg
DMX
Address
DIP Switches
1
2
4
8
16
32
64 128 256
1
1
0
0
0
0
0
0
0
0
2
0
1
0
0
0
0
0
0
0
3
1
1
0
0
0
0
0
0
0
…
..
..
..
..
..
..
..
..
..
410
0
1
0
1
1
0
0
1
1