AVSL 160.569 SW-1 MINI SNOW MACHINE - Manual (Page 4)

160.569UK User Manual
SETUP:
1.
Unpack the snow machine
2. Unscrew the top cap of the tank and remove to fill with the recommended
snow fluid
3. Replace the bottle and screw the cap securely ensuring the pipe is fed down to
the bottom of the bottle so a consistent flow of fluid is supplied to the machine
4. Connect the remote control
5. Connect the IEC mains plug and power up
6. Press the button on the remote control for 5 seconds so the fluid has a chance
to flow through the heater block making it ready to use..
7. After this you will be able to use the snow machine by pressing the button on
the remote when you require. Note it is normal for the machine to make a
loud noise during use.
CAUTION! TO PREVENT MORTAL ELECTRICAL RISK AND LONG LIFE OPERATION:
For your safety, please kindly pay attention to all of the warnings listed below:
Always plug in the power plug last and disconnect from the mains when the
device is not in use or before cleaning.
Do not install and operate the device in rain or extreme heat, moisture or dusty
environments.
This device is for indoor use only and in a dry environment.
Do not switch on immediately but wait until it reaches to room temperature if
the device has been exposed to drastic temperature fluctuations.
Do not shake the device and avoid brute force when installing or operating
Do not use the device during thunderstorms and please disconnect the power.
Do not use solvents or aggressive detergent to clean the device. Use a soft and
clean cloth.
Do not modify the device or the connected power cord without authorisation.