AVSL 160.456 QTFX-V1 - Manual (Page 2)

160.456UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the QTFX-V1 as part of your stage effects system. This machine is
designed to provide powerful fog output and reliable service for spectacular stage effects.
Please read these instructions fully to gain the best results and avoid damage through misuse.
Unpacking
Your QTFX-V1 should reach you in good condition and should be supplied with IEC mains
lead(s) and wireless remote fob. If there are any signs of damage or items missing from the
packaging, contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the
QTFX-V1 to dry out and have it checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open. Refer all servicing to qualified personnel.
Allow the QTFX-V1 to acclimatize to room temperature before operating.
Placement
The fixture may be mounted in any position provided there is adequate room for ventilation
and the fluid cannot leak out. When selecting installation location, take into consideration
refilling the tank and routine maintenance. If mounting at height, safety cables should be
used. Never mount in places where the fixture will be exposed to rain, high humidity, extreme
temperatures changes or restricted ventilation. Also do not mount vertically above people as
occasionally condensation builds up and the fluid may be hot.
Safety
 Check for correct voltage and condition of IEC lead before connecting to power outlet
 This unit must be earthed
 This unit uses a heating element - do not touch the output nozzle area whilst in use!
Cleaning
 Use a soft dry or slightly damp to clean the casing
 Do not use strong solvents for cleaning the unit
 It is recommended to use fog machine cleaning fluid (160.670UK) periodically