Armasight IAIR850IR000001 IR850 Detachable Long Range Infrared Illuminator - Manual (Page 2)

IR IllUMINATOR INSTAllATION
The IR810/IR850/IR940/IR810W/IR850W are the removable devices that can be installed on the rail of
night vision device (NVD). To install the IR illuminator on your NVD, perform the following steps:
1) Install the Picatinny adapter on the rail of your NVD (if Picatinny rail not installed on your NVD).
2) Loosen the fixing screw on the IR illuminator mount.
3) Place the IR illuminator on the Picatinny rail.
4) Tighten the fixing screw.
BATTERY INSTAllATION
CAUTION:
Ensure that the IR illuminator is off before installing the battery.
The Armasight IR illuminators runs on one CR123A battery. Install the battery as follows:
1) Unscrew the battery cap.
2) Install the battery into the battery compartment. Align the plus sign on the battery with the plus
sign on the cap face.
3) Replace the battery cap.
IR IllUMINATOR OPERATION
CAUTION:
Device is equipped with an infrared LED which is nit hazardous to human health. However do not
point the IR illuminator at eyes.
To switch the IR ON, rotate the operation switch from the OFF position.
The power of the beam emitted by the IR illuminator can be changed. To change the brightness of
the beam, rotate the illuminator operation switch. The positions of brightness levels are marked on
the back side of cap with dots of a different size, respectively to four different radiation output power
levels.
You can change the field of coverage by adjusting the IR beam.
To focus the beam, rotate the IR illuminator lens until the de-
sired field of coverage is reached.
Adjust the IR spot position in the field of view of the NVD as
follows:
1) Loosen the screw of the clamp on the IR illuminator mount.
2) Turn on the sight and the IR illuminator.
3) Carefully move the lens of the IR810/IR850 up and down and
side to side. While looking through the eyepieces of your de-
vice, observe the IR spot position.
4) Once the IR spot is centered in the field of view, tighten the
fixing screw of the clamp.
dElIVERY SET
IR illuminator, CR123A Lithium battery, User’s manual, Allen keys, Bracket*, Picatinny Mount Adapter*.
* Optional equipment or equipment with variants.
focus adjustment
fixing screw
battery cap
operation switch
screw of clamp
beam direction
adjustment
picatinny adapter
Armasight Inc.
815 Dubuque Avenue, South San Francisco, CA 94080
[email protected], www.armasight.com
Phone: (888)959-2259
Fax: (888)959-2260
Intl Phone/Fax: (650)492-7755