Armasight DKMPRIMDC040001 Prime DC 4x Digital Color Night Vision Monocular - Manual (Page 7)

7
PREPARATIOn FOR STORAGE
When preparing your Prime DC for storage, perform the following steps:
1) Verify that the monocular is operating in accordance with all previously specified procedures.
2) Remove the battery from the battery compartment.
3) Clean the monocular and all accessories.
4) Place all components into the storage case.
cAuTIOn:
Each component of the unit should be thoroughly dried before placing them into the storage
case.
5. TROuBlESHOOTInG
Common problems that may occur with your monocular or the detection and viewing tests, as well as
actions you can take to correct them, are listed in the Troubleshooting Table, below. This table does
not list all of the malfunctions that may occur with your device. If you experience a malfunction of
the device that is not listed in this table, please contact Armasight or your Prime DC retailer.
nOTE:
Before you use this table, be sure you have performed all normal operational safety, care and
handling checks and procedures. If you have a malfunction which is not listed in this table,
notify the next higher level of maintenance.
TROuBlESHOOTInG GuIDE
PROBlEM POSSIBlE cAuSE AcTIOn
The monocular does not turn on
Press the Power button. Press the Power button repeatedly.
Inspect for a missing, defective or im-
properly installed battery.
Replace the battery or install it prop-
erly.
If these actions fail, turn in the device for unit level maintenance.
Poor image quality
Check if the eyepiece and lens are fo-
cused.
Focus the ocular and lens.
Check if the lens is greasy, fogged or
dirty.
Thoroughly clean the surface of the
lens.
If the problem persists, contact your service center.
Light is visible through the eyecup
Check the exit pupil distance value. Press the eyecup to your face.
Check the resilience of the eyepiece.
If the eyecup is defective, contact your
service center.
Diopter adjustment cannot be per-
formed
Check to see if the diopter adjustment
ring is deformed or broken.
If the diopter adjustment ring is dam-
aged, contact your service center.
IR illuminator does not turn on
Turn the IR illuminator on in a dark area
with the monocular on. Visually estimate
if the observed scene is lighted.
If the IR illuminator does not turn on,
contact your service center.