Asus RT-G32 - Manual (Page 27)

7 Chapter 5: Installing the utilities RT-G3
Set IP address manually
Click Start > Control Panel > Network Connection. Right-click Local Area
Connection then select Properties.
Set the IP address manually (19.18.1.54).
3. Power off the wireless router, press and hold the reset button and then power
on the device again. The wireless device enters the rescue mode after the
WLAN LED flashes.
DO NOT shut down or reset the device while updating the firmware! Doing so can cause system
boot failure!
• We suggest you use wired connection and set the IP address manually in order to gain an
ideal environment for transmission.
• Make sure firewall on PC is disabled.