Asus WL-330g - Manual (Page 49)

ASUS Pocket Wireless Access Point (WL-330g) 3-25
Scan Mode. This field allows you to select the scan mode for button
scanning. Click to display available options.
Find the connection with the strongest link quality- When the reset button is
pressed for less than 5 seconds, the ASUS Pocket Wireless AP
connects to an AP or wireless device with the strongest link quality.
Same as the above mode but only in the profile table - When the reset
button is pressed for less than 5 seconds, the ASUS Pocket Wireless AP
searches for an AP or wireless device in the Profile Table, then connects
to the one with the strongest link quality.
Same as the above mode but find extra site in my location- When the reset
button is pressed for less than 5 seconds, the ASUS Pocket Wireless AP
searches for an AP or wireless device in the Profile Table and in your
location, then connects to the one with the strongest link quality.
Profile Scan (total x)- This mode allows you to connect to a saved wireless
network by their sequence in the Profile Table. Press the reset button
once to connect to the first wireless connection in the Profile Table.
Press again to connect to the second wireless connection, and so on.
For example, if you have three saved profiles in the profile table, the
ASUS Pocket Wireless AP automatically connects to the first profile.
Press the reset button to connect to the second saved profile. Press the
reset button again to connect to the third saved profile.
Specified profile scan (just no. x)- When the reset button is pressed for less
than 5 seconds, the ASUS Pocket Wireless AP automatically connects to
the specified profile. The saved profiles are numbered from 1 ~ x. You
must select the profile number using the Specified Profile field.
When using the Alphabet Scan, the AP or wireless device you wish
to connect to must have a disabled WEP encryption and available
SSID.
Specified Profile. This field allows you to select a saved wireless network in
the Profile Table. The ASUS Pocket Wireless AP automatically connects to
the selected profile when Scan Mode is set to Specified profile scan.
Click Apply when done. Otherwise, click Restore to load the default values.