Asus V3-M3A3200 - Manual (Page 71)

4-11 ASUS V2/V3-M3A3200
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “GND” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
M3A78-EM Intrusion Connector
R
M3A78-EM
CHASSIS
+5VSB_MB Chassis Signal GN
D
(Default)
12. IEEE 1394a port connector (10-1 pin IE1394_1)
This connector is for a IEEE 1394a port. Connect the IEEE 1394a module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
M3A78-EM IEEE 1394a Connector
R
M3A78-EM
IE1394_1
GN
D
+12V TPB1
-
GN
D
TP
A1
-
+12V
TPB1
+
GN
D
TP
A1
+
1
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage
the motherboard!