Asus AP7500 - Manual (Page 30)

30 AP7500 Hardware Reference Guide
II. Components
Power Supply
II. System Components
Power Supply
This server has a special redundant power supply with specifications to sur-
pass this server’s requirements. A clearly marked label gives detailed speci-
fications of the power supply. A power switch is not provided therefore it is
necessary to remove the power cord before opening the side panel in order
to shut off the standby power. With the power cord removed, you can ensure
there are no voltages which can cause shorts while installing or removing
internal components.
CAUTION: Before turning ON your server for the first time, set the power
supply’s voltage. Some products may have auto voltage switching to ac-
commodate 220V-240V or 110-120V but this power supply must be set
manually. The factory default should be on 230V to accommodate the higher
voltage but it is safer to visually inspect the switch yourself in case it is not.
Using the power modules set on 115V in 230V environments may cause
damage to the power modules.
IMPORTANT: For countries using 110V-120V, you must slide the switch
to 115V or else power up is not possible (but no damage will occur).
Power Supply Mounting
The redundant power supply is swappable within its own frame. Two screws
secure the power supply in the inserted position. The entire frame can also
be unscrewed for servicing if necessary. A support brace must be used to
support the frame under the inner edge. The support brace can only be se-
cured after the power supply frame is inserted and must be removed before
the power supply frame is removed from the chassis. There are four screws
securing the power supply support brace as circled below.
Power supply with frame halfway inserted
Top power module
Bottom power
module
Power supply frame Power supply
support brace
Screwdriver
Securing power supply support brace