Hotpoint Ariston Luce FK 1041L P.20 X-HA - Manual (Page 25)

GB
25
! The first time you use your appliance, heat the
empty oven with its door closed at its maximum
temperature for at least half an hour. Make sure that
the room is well ventilated before switching the oven
off and opening the oven door. The appliance may
emit a slightly unpleasant odour caused by
protective substances used during the
manufacturing process burning away.
! Turn the control dial to adjust the parameter shown
on the display between the “<” and “>” symbols.
! To make the setting process easier, keep the
control dial in position: this will increase the scrolling
speed of the numbers on the display.
! Each setting will automatically be stored in the
appliance memory after 10 seconds.
! The touch controls cannot be activated if the user
is wearing gloves.
Some models are equipped with a system of hinges
which allows the door to close slowly, without the
user having to follow the movement through with his/
her hand. To use the system correctly, before
closing the door:
• Open the door fully.
• Do not force the closing movement manually.
Switching the oven on for the first time
After connecting the oven to the electricity supply,
the first time it is switched on the user should also
switch on the control panel by pressing the
button. The list of languages will appear in the
menu. To choose the desired language, select it
using the control dial. Confirm by pressing the
icon.
Once the selection has been made, the display will
show the settings menu. Press the icon or scroll
through using the control dial until you reach the
EXIT command and press the icon to begin
using the oven.
! After choosing the language in the menu, if the
display is not used for another 30 seconds it will
automatically revert to programming mode.
Setings menu commands
To enter the settings menu, switch on the control
panel and press the
icon.
Use the control dial to highlight the individual menu
commands.
To modify the setting, press the icon.
The following parameters are listed in the menu:
LANGUAGE: select the language shown on the
display.
PYROLYTIC: select the cleaning type.
CLOCK: set the exact time.
TONE: activate/deactivate keypad tone.
LIGHT: activate/deactivate the internal oven light
during cooking.
LOGO: activate/deactivate logo on start-up.
GUIDE: activate/deactivate operating tips.
EXIT: exit the menu.
! It is possible to exit the settings menu by pressing
the
icon.
Control panel/door lock
! The door and control panel can be locked while the
oven is off, once cooking has started or finished and
during programming.
The door/control panel lock can be used to lock the
oven door and/or controls.
To activate it, press the
icon and select the
desired command by pressing the control dial:
• NO LOCK: deactivate an active lock;
• ONLY BUTTONS: only lock the controls;
• ONLY DOOR: only lock the door;
• BUTTONS AND DOOR: lock the controls and the
door.
Confirm by pressing the icon.
A confirmation buzzer will sound and the icon will
appear on the display.
The lock may be activated while the oven is in use,
or while it is switched off. It can also be deactivated
in all the above situations and after the oven has
finished cooking.
! When cleaning the appliance, the door lock may be
closed accidentally (there is an exposed spring). If
this happens, reopen it by turning the door lock
upwards (see figure).
KO KO OK OK
Setting the clock
To set the clock, switch on the oven by pressing the
Start-up and use