Asus DSL-N10S - Manual (Page 30)

30 DSL-N10S Chapter 4: Configuring via the web GUI
Configuring the wide area network (WAN) settings
The WAN page allows you to configure your wide area network (WAN) settings.
To configure the WAN settings:
Click Network > WAN tab > WAN.
In the Default Route Selection field, select Auto or Specified.
In the VPI field, key in the virtual path values for the asynchronous transfer
mode ranging from 0 to 55.
In the VCI field, key in the virtual channel values for the asynchronous
transfer mode ranging from 3 to 65535.
In the Encapsulation dropdown list, select LLC or VC-Mux.
In the Channel Mode dropdown list, select 1483 Bridged, 1483 MER, PPPoE,
PPPoA, 1483 Routed, or IPoA.
Tick Enable NAPT to enable Network Address Port Translation function. Tick
Enable IGMP to enable Internet Group Management Protocol function.
1.
.
3.
4.
5.
6.
7.
Configuring the WAN channel
The Channel Configuration page allows you to configure the Internet settings in
WAN channel.
To configure the PPP settings:
In the User Name and Password fields, key in a user name and password
provided by your ISP.
In the Type dropdown list, you can select Continuous, Connect on
Demand, or Manual.
In selecting the Connect on Demand type, key in the idle amount time in Idle
Time (min) field to automatically disconnect the PPPoE connection.
1.
.
3.