beautypg.com

Maintenance and care – Hotpoint Ariston Una puerta SDS 1722 J-HA User Manual

Page 14

background image

14

GB

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to

disconnect the appliance from the electricity supply:

It is not sufficient to set the temperature adjustment

knobs on OFF (appliance off) to eliminate all electrical

contact.

Cleaning the appliance

• The external and internal parts, as well as the rubber

seals may be cleaned using a sponge that has been

soaked in lukewarm water and bicarbonate of soda

or neutral soap. Do not use solvents, abrasive

products, bleach or ammonia.

• The removable accessories may be soaked in warm

water and soap or dishwashing liquid. Rinse and dry

them carefully.

• The back of the appliance may collect dust which

can be removed by delicately using the hose of a

vacuum cleaner set on medium power. The

appliance must be switched off and the plug must be

pulled out before cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic

materials which are odour free. In order to maintain

an odour free refrigerator and to prevent the

formation of stains, food must always be covered or

sealed properly.

• If you want to switch the appliance off for an

extended period of time, clean the inside and leave

the doors open.

1

1

2

Defrosting the appliance

! Follow the instructions below.

Do not use objects with sharp or pointed edges to

defrost the appliance as these may damage the

refrigeration circuit beyond repair.

The refrigerator has an

automatic defrosting

function: water is ducted

to the back of the

appliance by a special

discharge outlet (see

diagram) where the heat

produced by the

compressor causes it to

evaporate. It is

necessary to clean the

discharge hole regularly so that the water can flow out

easily.

Replacing the light bulb

To replace the light bulb in the refrigerator

compartment, pull out the plug from the electrical

socket. Follow the instructions below.

Access the light bulb by removing the cover as

indicated in the diagram.

Replace it with a similar light bulb within the power

range indicated on the cover (15W or 25W).

This manual is related to the following products: