Asus P4T533-C - Manual (Page 32)

18 Chapter 2: Hardware information
2.5.2 Installing Memory
The memory module (RIMM) will fit in only one orientation.
Do not touch the memory module’s connectors. Handle the module
only by the edges.
P4T533-C
®
P4T533-C 184-Pin RIMM Sockets
RIMM Sockets
RIMM with Heat Spreader
C-RIMM
NOTCH KEYS
CONNECTORS
RDRAM (with heat spreader) MOUNTING NOTCH
RIBS (inside socket) EJECTOR
(TOP VIEW)
2. With the ejectors in the open position (as shown), push down gently but
firmly on the memory module until it snaps into place. The guides on the
socket’s ejectors should go through the two mounting notches on the
module and the ejectors should close. If necessary, push the ejectors
inward to secure the module in place.
1. Make sure that the notch keys in the module are aligned with the small
ribs inside the RIMM sockets.
No hardware or BIOS setup is required after adding or removing memory.