Asus Eee PC MK90H - Manual (Page 56)

Chapter 4: Support DVD & System Recovery 4-6
Boot Booster
The Boot Booster item in BIOS setup helps shorten your Disney Netpal
bootup time. However, you MUST disable this BIOS item before you
change any Disney Netpal components or perform system recovery
(from USB flash disk, external optical drive or hidden partition). Follow the
instructions below to disable Boot Booster:
1. Start the system and press on bootup to show the POST
screen. Press again to enter the BIOS setup.
2. Set Boot Booster to [Disabled]
v02.58 (C)Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
Main Advanced Security Boot Exit
Boot Device Priority
Boot Settings Configuration
OnBoard LAN Boot ROM [Enabled]
Boot Booster [Disabled]
←→ Select Screen
↑↓ Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
Specifies the Boot
Device Priority
sequence.
A virtual floppy disk
drive (Floppy Drive B:
) may appear when you
set the CD-ROM drive
as the first boot
device.
3. Press to save the configuration and restart Disney Netpal.
If you fail to see the POST screen or enter the BIOS setup by doing
the instruction above, restart the system and try pressing
repeatedly on bootup.
Remember to enable Boot Booster after you complete hardware
change or system recovery.