Asus P2B-S - Manual (Page 20)

20 ASUS P2B-L/P2B-S/P2B-LS User’s Manual
III. INSTALLATION
CPU
III. INST
ALLA
TION
Attach Mount Bridges
Four screws should be showing next to each corner of the SEC CPU Slot with the
two attach mount bridges installed.
Installing the Pentium II Processor
1. Mount the Pentium II Retention Mechanism: The retention mechanism is
designed to fit into the SEC slot only one way.
TIP: Orient the mechanism’s lock holes toward the motherboard’s chipset (see moth-
erboard layout for the location of the AGPset).
Be sure to align the notch in the mechanism with the small rib on one side of the
slot and that the mechanism is properly seated on the board. Then, screw the
captive nuts in place.
WARNING! Do not overtighten the captive nuts. Doing so could damage your
motherboard. Tighten captive nuts to no more than 6±1 inch/pound.
Lock holes
Captive nut
Captive nut
NOTE: Encircled items are the screws
from the mount bridges (1 & 2)
SEC CPU slot
Attach Mount Bridges (underside)