Asus V3-P5G31 - Manual (Page 41)

2-23 ASUS V-Series P5G31
2.11 Re-connecting cables
You may have disconnected some cables when you were installing components.
You must re-connect these cables before you replace the chassis cover.
LED cables
Connect the reset button, power switch, power LED, and HDD LED cables to their
respective leads in the system panel connector on the motherboard.
HDD LED
Power LED
Power Switch
Reset button
I
5. Connect the other end of the signal cable to the floppy disk drive connector
on the motherboard. See page 4-6 for the location of the floppy disk drive
connector.
6. Connect a 4-pin power cable from the power supply unit to the power connector
at the back of the floppy disk drive.
R
System Panel Connector
F_PANEL
PLED
-
PW
R
PLED
+
Ground
GN
D
Reset
IDELED
+
IDELED
-
+HD LED RESET
PLED PWRBTN