Asus P5BV-C - Manual (Page 103)

ASUS P5BV-C Series 5-7
5.3.1 Creating a RAID 0 set (stripe)
To create a RAID 0 set:
1. From the utility main menu, select 1. Create RAID Volume, then press
. This screen appears.
2. Enter a name for the RAID 0 set, then press .
3. When the RAID Level item is highlighted, press the up/down arrow key to
select RAID 0(Stripe), then press .
4. When the Disks item is highlighted, press to select the hard disk
drives to configure as RAID. This SELECT DISKS screen appears.
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reserved.
[ CREATE ARRAY MENU ]
[ DISK/VOLUME INFORMATION ]
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive and
cannot contain special characters.
[↑↓]-Change [TAB]-Next [ESC]-Previous Menu [Enter]-Select
Name:
RAID Level:
Disks:
Strip Size:
Capacity:
Volume0
RAID0(Stripe)
Select Disks
128KB
0.0 GB
Create Volume
[ SELECT DISKS ]
[↑↓]-Previous/Next [SPACE]-Selects [ENTER]-Selection Complete
Port Drive Model Serial # Size Status
0 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
1 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
2 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
3 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
Select 2 to 4 disks to use in creating the volume.
5. Use the up/down arrow key to highlight a drive, then press to
select. A small triangle marks the selected drive. Press after
completing your selection.