Zanussi ZRX407W - Manual (Page 27)

Problem Possible cause Solution
There is too much frost. The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not set
correctly. Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension
Height 520 mm
Width 525 mm
Depth 587 mm
Voltage 230 V
Frequency 50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a
location where the ambient temperature corre-
sponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
27
www.zanussi.com