Zanussi ZRX407W - Manual (Page 26)

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Important! The appliance operates
discontinuously, so the stopping of compressor
does not mean being no current. That is why
you must not touch the electrical parts of the
appliance before breaking the circuit.
Problem Possible cause Solution
The appliance is noisy The appliance is not supported
properly Check if the appliance stands stable
(all the four feet should be on the
floor)
The appliance does not
operate. The appliance is switched off. Switch on the appliance.
The mains plug is not connected to
the mains socket correctly. Connect the mains plug to the mains
socket correctly.
The appliance has no power. There
is no voltage in the mains socket. Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
The compressor operates
continually. The temperature is not set correct-
ly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently. Do not keep the door open longer
than necessary.
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear
plate of the refrigerator. During the automatic defrosting
process, frost defrosts on the rear
plate. This is correct.
The temperature in the ap-
pliance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the ap-
pliance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time. Store less products at the same
time.
The temperature in the re-
frigerator is too high. There is no cold air circulation in
the appliance. Make sure that there is cold air circu-
lation in the appliance.
26
www.zanussi.com