Asus VX5 - Manual (Page 68)

A-8
System BIOS Settings (cont.)
Password Check
Select whether to ask for
a password during bootup
(Always) or only when
entering the BIOS setup
utility (Setup).
Select the level of access
to allow the “User Pass-
word” to have in the BIOS
setup utility.
User Access Level
Save Changes
If you want to keep your
configuration settings, you
must save changes before
exiting the BIOS setup
utility.
If you want to restore
default settings, choose
Load Setup Defaults. You
must then save changes
to keep the manufacture
default settings.
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
Security
Security Settings
Supervisor Password : Installed
User Password : Installed
Change Supervisor Password
User Access Level [Full Access]
Change User Password
Clear User Password
Password Check [Setup]
Hard Disk Security Setting
I/O Interface Security
Setup: Check password
while invoking setup.
Always: Check password
while invoking setup
as well as on each
boot.
Options
Disabled
Enabled
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
Security
Security Settings
Supervisor Password : Installed
User Password : Installed
Change Supervisor Password
User Access Level [Full Access]
Change User Password
Clear User Password
Password Check [Setup]
Hard Disk Security Setting
I/O Interface Security
Trusted Computing
Setup: Check password
while invoking setup.
Always: Check password
while invoking setup
as well as on each
boot.
Options
No Access
View Only
Limited
Full Access
Select Screen
Select Item
Enter Go to Sub Screen
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
Main Advanced Security Power Boot Exit
Exit Options
Save Changes and Exit
Discard Changes and Exit
Discard Changes
Load User Defaults
Load Manufacture Defaults
Exit system setup after
saving the changes.
F10 key can be used for
this operation.
A
Appendix