Asus SL200 - Manual (Page 35)

SL200.User.Manual . Chapter.3.Router.Setup
31
NAT-Traversal:.Enable.the.NAT-Traversal.functon.
Dead Peer Detection:.Enable.Dead.Peer.Detecton.functon
DPD Delay Time:.Interval.Delay.Tme.between.DPD.messages
DPD Retry Time:.Interval.between.DPD.messages.when.no.reply.
from.remote.gateway.
DPD Max Failures:.The.maxmal.tme.falures.of.DPD.
Anti-replay:.Enable.the.Ant-replay.functon.
Keep Alive:.Enable.the.Keep.Alve.functon.
Counter Measure:.Enable.the.counter.Measure.functon.
Max Failures:.The.maxmal.tme.falures.of.Counter.Measure.
Block Interval:.Block.Interval.between.Counter.measure..
3.6 LAN
3.6.1 LAN Settings
Configure the gateway address of the router. To dynamically assign
the IP address for clients’ PCs, enable the DHCP Server, set the
lease.tme,.and.then.specfy.the.address.range..Vald.IP.addresses..
consist of four numbers, which are separated by periods. The first
three fields are the network portion ranging from 0 to 255, while the
last field is the host portion ranging from 1 to 254.