6 power menu, Acpi function [enabled, Acpi suspend mode [s1 (pos) – Asus A7V8X-MX User Manual
Page 52: Power management option [user define, Hdd power down [disabled, Auto suspend timeout [disabled, Video off option [suspend -> off, Video off method [dpms support

2-22
Chapter 2: BIOS Information
2.6
Power Menu
ACPI Function [Enabled]
Allows you to enable or disable the ACPI 2.0 support.
Configuration options: [Enabled] [Disabled]
ACPI Suspend Mode [S1 (POS)]
Allows you to select the ACPI state to used for system suspend.
Configuration options: [S1 (POS)] [S3 (STR)] [S1 & S3]
Power Management Option [User Define]
Configuration options: [Min Saving] [Max Saving]
HDD Power Down [Disabled]
Shuts down any IDE hard disk drives in the system after a period of inactivity as
set in this user-configurable field. This feature does not affect SCSI hard drives.
Configuration options: [1Min]...[15Min]
Auto Suspend Timeout [Disabled]
Sets the time period before the system goes into suspend mode. Configuration
options: [1Min] [2Min] [4Min] [6Min] [8Min] [10Min] [20Min] [30Min] [40Min] [1Hour]
Video Off Option [Suspend -> Off ]
This field determines when to activate the video off feature for monitor power
management. Configuration options: [Always On] [Suspend -> Off]
Video Off Method [DPMS support]
This field defines the video off features. The Display Power Management System
(DPMS) feature allows the BIOS to control the video display card if it supports the
DPMS feature. [Blank Screen] only blanks the screen. Use this for monitors without
power management or “green” features. Configuration options: [V/H Sync+Blank]
[Blank Screen] [DPMS support]
ACPI Function
[
Enabled
]
ACPI Suspend Mode
[S1 (POS)]
Power Management Option
[User Define]
HDD Power Down
[Disabled]
Auto Suspend Timeout
[Disabled]
Video-off Option
[Suspend -> Off]
Video Off Method
[V/H Sync+Blank]
PWR Button < 4 Sec
[Instant-off]
Run VGA BIOS if S3 Resume
[Auto]
AC Loss Auto Restart
[Previous State]
Shutdown Temperature
[Disabled]
C.O.P. Control
[85 degree]
Power Up Control
Hardware Monitor
Press [Enter] to
select [Enabled] or
[Disabled].