GC EUROPE GRADIA - Manual (Page 17)

EI1
CT2
14. HALO ENAMEL (HE)
For deeper, richer colour, apply
(CT) at cervical area towards tooth
center. Apply ENAMEL INTENSIVE at incisal
edge towards cervical area for natural
appearance. Add HALO ENAMEL to proximal
areas to accentuate tooth contour.
15. FINAL BUILD-UP 16. AIR BARRIER 17. FINAL LIGHT CURING
Application is complete on labial
surface. Remove silicone index. Apply
ENAMEL INTENSIVE (EI) on the
lingual surface as needed. Immediately coat surface with
GC GRADIA AIR BARRIER to
eliminate air inhibition layer and to
ensure complete polymerization. After applying GC GRADIA AIR
BARRIER, light cure. Remove
GC GRADIA AIR BARRIER with
water, after final polymerization.
Note: To add resin, first roughen
resin surface with bur, coat with
GC COMPOSITE PRIMER and
light cure 1 min. in GC LABOLIGHT
LV-III. Adjust surface
Refine surface texture with diamond
or carborundum points. Smooth with
silicone points.
Light cure: see chart 2
GC LABOLIGHT LV-II, III 3 minutes
GC LABOLIGHT LV-I 5 minutes
Chart 3 – Final curing time
15
HE1 HE1
EI1
CT2
Apply added material, DENTIN,
ENAMEL or ENAMEL INTENSIVE
and light cure 3 min. Then
characterize surface with diamond
and carborundum points. Finish
Finish surface with Robinson Brush
together with GC GRADIA
DIAPOLISHER. Polish & Buff
Use GC GRADIA DIAPOLISHER on
felt or chamois wheel for a lustrous
finish.
Light cure: see chart 2 Light cure: see chart 2
12. CERVICAL TRANSLUCENT (CT) 13. ENAMEL INTENSIVE (EI)
GC STEPLIGHT SL-I 10 seconds
GC LABOLIGHT LV-II, III 30 seconds
GC LABOLIGHT LV-I 60 seconds
Chart 2 – Curing time for Dentin/Enamel
bodies and intensive colours
Light cure: see chart 3 Light cure: see chart 2
18. ADJUST CONTOUR
Adjust contour with diamond and/or
carbide burs. Refer to page 16 for
additional composite applications.