Media-Tech PULSAR PRO BT User Manual
Pulsar pro bt, Mt3552, User manual
Stereo Bluetooth Headset
Pulsar Pro BT
MT3552
Pairing with mobile phone
1. Make sure that headset is charged, mobile phone is
turned on and Bluetooth function is active.
2. Power off the headset, then press and hold
until
red and blue LED will fl ash alternately.
3. Run scanning for Bluetooth devices in your mobile
phone.
4. When prompted enter password “0000”. Some mo-
bile phones do not require password.
EN
User Manual
Overview
Operating
Function
Operation
Power on
Press and hold
until blue LED will blink 3 times.
Power off
Press and hold
until blue LED blink, red LED will
blink 3 times and go off .
Pairing mode
Press and hold
until blue and red LED will fl ash
alternately.
Play/Pause
Press
Next/Previous
Press and hold +/-
Adjust volume
Press +/-
Answer/End call
Press
Reject call
Double press quickly
Redial last number
Double press quickly
Start up voice dialing*
Press and hold
until sound is played
Switch call
Press and hold
until sound is played
* Function depends on mobile phone capabilities
Specifi cation and appearance of product are subject to change without prior notice.
For technical support please visit www.media-tech.eu.
Charging
Use USB cable to plug device to USB port in your PC computer. During charging red LED will be on, when fully
charged red LED will be off .
Note! During charging device is always in off mode. When rechargeable battery is running low, red LED will
blink, charge the device.