Media-Tech DVB-T2 HD DIGITAL TV BOX - Manual (Page 16)

EN
Troubleshooting Technical Specifi cation
Trouble Cause Solution
STANDBY indicator did
not light Power cord is not plugged in
Burnout fuse Check the power cord
Contact with service
Out of signal Antenna is not connected
to receiver
Incorrect direction of an-
tenna or antenna damaged Check aerial cord
Change aerial direction
No sound or video Video source option in TV
is wrong Choose SCART/AV
video source option
on TV
Unclear subtitles Poor signal level Change aerial direction
Reset channel list
Remote control doesn’t
work Receiver is turned off
Incorrect remote direction
IR receiver is not visible by
IR remote
Batteries are discharged or
incorrectly installed Turn on receiver
Correct direction of
remote
Remove obstacle
Change or correct bat-
teries installation
Lost channel lock
password Prescan all channels
again
Lost menu lock password Contact with Media-
Tech helpdesk
Out of signal after install-
ing device in other place Antenna with longer cord
need more power Use external power
supply for antenna
Tuner RF Input (IEC-TYPE, IEC 169-2, female)
RF Output RF (IEC-TYPE, IEC 169-2, male)
Frequency range:
174~230MHz (VHF)
470~862MHz (UHF)
Signal Level: -15~-70dbm
Decoder:
Video Decoder
Audio Decoder
Transfer Speed
Aspect Ratio
Audio Formats
Video Output
MPEG-1/MPEG-2 MP@ML/MPEG-4 AVC/H.264 HP@L3
MPEG-1 Layer 1.2/PCM/HE-AAC v.1.0
Max 15 Mbit/s
4:3/16:9
MPEG Layer I & II, 32/44.1/48 kHz
CVBS, RGB
Connectors:
Antenna
Video
Audio
Data
RF output x 1, RF input x 1
HDMI, SCART, CVBS Composite Video, YPbPr Component Video
Composite Audio, Coaxial Digital Audio
USB
Power:
Input Voltage
Power
Consumption
AC 220~240V, 50/60Hz
Max 8W
Note! Design and equipment specifi cations are subject to change
without notice.