SCANTECH ID (Champtek company) LIBRA L-7080i - Manual (Page 18)

12
Changing the interface cables
To change the interface connection, follow the steps below:
1. Hold the LIBRA L-7080i upside down.
2. Remove the attached cable.
3. Connect the desired interface cable to LIBRA L-7080i.
4. Align the cable through the cable hook.
5. Connect the other end of the interface cable to your host system.
6. If necessary, mount the scanner on the wall using the wall hooks.
2.3 ADJUSTING
LIBRA L-7080i’s angle can be adjusted. To do this, hold LIBRA by its back and adjust the
angle as shown below.
Front angle: 22° (max) / Back angle: 80° (max)
Wall hooks