SCANTECH ID (Champtek company) SIRIUS S-7030 - Manual (Page 21)

Installation 15
2.4 CONTROLLING THE SCANNER FROM THE POS SYSTEM
The Sirius S-7030 can be controlled from the POS system via the RS-232
interface or USB/COM Port Emulation. Control is achieved by transmitting the
following single byte commands to the scanner. In the Scantech default setting
the following commands are available (more details available upon request):
ASCII code
05
Hex
OE
Hex
OF
Hex
12
Hex
14
Hex
Function
Power-up re-initialization
Enable (cancels disable)
Disables the scanner
Puts scanner into Sleep
Wake (cancels sleep)
Byte is also called:
ENQ or
Shift Out or
Shift In or
DC2 or
DC4 or
When the scanner is disabled, the motor of the scanner will stay on,
until the scanner goes into sleep mode.
2.5 STANDARD AVAILABLE INTERFACE CABLES
On the next pages you see the standard available interface cables with some
additional information.
Note that the power injector may be used to insert the DC power from the
optional external power supply. However if your POS/PC system provides
sufficient power directly via the data port, no external power supply is required.
A safety measure prevents from damage in case you connect a power supply
where it is not required (by disconnecting the power from the POS/PC system).
If you are using the Sirius with USB interface, no external power supply is
required at all.