SCANTECH ID (Champtek company) LG700BT - Manual (Page 47)

39
4.14.4 Setup Code Length
To set the fixed length: (2 sets available)
1. Scan the “Begin” programming code of the desired
set
2. Go to the Decimal Value Table in Appendix A. Scan
programming codes that represent the length to be
read.
3. Scan the “Complete” programming code of the desired
set.
Repeat the steps 1 – 3 to set additional length.
Fixed Length 1
st
Set
1
st
Set Begin
Decimal Value See Appendix A
1
st
Set Complete
Fixed Length 2
nd
Set
2
nd
Set Begin
Decimal Value See Appendix A