SCANTECH ID (Champtek company) LG700BT - Manual (Page 16)

8
ATTENTION
The LG700BT scanner must be charged for a
minimum of 8 hours before the scanner can be
placed in full operation for the first time.
The scanner LED will indicate in red when the
scanner is charged.
After the battery is full, the green LED on
scanner will be on. The charge green LED will
be off when the scanner leaving from cradle.
If the battery power of the LG700BT is too low,
the LG700BT will indicate red LED and beeper
warning.
It is important to know that the LG700BT scanner will
only communicate with the cradle whose unique Bluetooth
MAC address was last scanned.
If a cradle is paired with the LG700BT scanner, another
LG700BT scanner can’t be paired with that cradle until
the original connection is interrupted.
If you pair a second LG700BT scanner to an in-use cradle,
the cradle’s connection to the first LG700BT scanner will
be interrupted and the connection will be re-established
with the second LG700BT scanner.