Procom DFA 2-70-Z-... - Manual

DFA 2/70-Z/...
Dual-frequency Mobile Antenna for the 160 and 450 MHz
Bands
DESCRIPTION
New whip design for optimum wind noise reduction.
This antenna makes it possible to:
– operate 160 and 450 MHz transceivers alternately on the same
antenna
– operate two transceivers (160 and 450 MHz) at the same time on one
antenna using a diplexer (type DIPX 225/330 – must be ordered
separately).
Only a single hole has to be drilled instead of two.
Car appearance is not destroyed by an “antenna farm”.
Ideal for covert services.
Stainless steel Z-mount with ball-joint and wing screw whip-fastening
system.
Simple mounting exclusively with access from the outside.
Models with roof thickness from 2 mm to 7.5 mm mounting from the
inside.
Choice between two connection principles:
Z-mount: FME-connection (supplied without cable).
ZP4-mount: Permanently attached 4 m cable terminated with FME-
connector.
ORDERING DESIGNATIONS
TYPE PRODUCT NO. MOUNT VERSION
DFA 2/70-Z/... 130000689 Z-mount with FME-system
DFA 2/70-ZP4/... 130000691 ZP4-mount with 4 m cable
and FME-connector
The antenna is delivered factory-tuned to two single frequencies, one
frequency in each band. These two frequencies (stated in MHz) must be
specified when ordering as can be seen from the ordering designations. In
case of duplex operation, only the TX frequency should be stated.
SPECIFICATIONS
ELECTRICAL
MODEL DFA 2/70-Z/...
ANTENNA TYPE Dual-frequency mobile antenna
FREQUENCY 160 MHz-band freq. to be stated within:
144…175 MHz
450 MHz-band freq. to be stated within:
380…470 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Vertical
GAIN 160 MHz: Approx. 0 dB
450 MHz: Approx. 2 dB
BAND WIDTH 160 MHz: ≥ 8 MHz @ SWR ≤ 2.0
450 MHz: ≥ 15 MHz @ SWR ≤ 2.0
SWR ≤ 1.5 @ f.res in both bands
MAX. POWER 30 W
MECHANICAL
MATERIALS Whip:
Conical glass fiber
Chromed brass
Mount:
Chromed brass
Weather- and shockproof plastics
Stainless steel
RECOMMENDED
INSTALLATION
TORQUE
7.5 ± 1 Nm
COLOUR Black
HEIGHT 53 cm
WEIGHT Z-version: Approx. 160 g
ZP4-version: Approx. 310 g
MOUNTING ø21 mm dia. hole (For roof thickness 2 mm
up to 7.5 mm mounting hole should be ø22 mm
dia.)
ROOF THICKNESS Max. 2.0 mm (Models up to 7.5 mm on request)