Procom DFA 4-70-z-... - Manual

DFA 4/70-Z/...
Dual-frequency Mobile Antenna for the 80 and 450 MHz
Bands
DESCRIPTION
New whip design for optimum wind noise reduction.
This antenna makes it possible to:
- operate 80 and 450 MHz transceivers alternately on the same antenna
- operate two transceivers (80 and 450 MHz) at the same time on one
antenna using a diplexer (type DIPX 225/330 – must be ordered
separately).
Only a single hole has to be drilled instead of two.
Car appearance is not destroyed by an “antenna farm”.
Ideal for covert services.
Stainless steel Z-mount with ball-joint and wing screw whip-fastening
system.
Simple mounting exclusively with access from the outside.
Models with roof thickness from 2 mm to 7.5 mm mounting from the
inside.
Choice between two connection principles:
Z-mount: FME-connection (supplied without cable).
ZP4-mount: Permanently attached 4 m cable terminated with FME-
connector.
ORDERING DESIGNATIONS
TYPE PRODUCT
NO.
FREQUENCY
PAIR
MOUNT
VERSION
DFA 4/70-Z/71.7/460.6 130000671 80: TX: 71.7
MHz
80: RX: 76.2
MHz
450: 460.6 MHz
Z-mount with
FME-system
DFA 4/70-Z/76.5/446.0 80: 76.5 MHz
450: 446.0 MHz
Z-mount with
FME-system
DFA 4/70-
ZP4/71.7/460.6
130000672 80: TX: 71.7
MHz
80: RX: 76.2
MHz
450: 460.6 MHz
ZP4-mount with
4 m cable and
FME-connector
DFA 4/70-
ZP4/76.5/446.0
80: 76.5 MHz
450: 446.0 MHz
ZP4-mount with
4 m cable and
FME-connector
SPECIFICATIONS
ELECTRICAL
MODEL DFA 4/70-Z/...
ANTENNA TYPE Dual-frequency mobile antenna
FREQUENCY 80 MHz-band freq. to be stated within: 66…88 MHz
450 MHz-band freq. to be stated within: 406…470 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Vertical
GAIN 80 MHz: Approx. 0 dB
450 MHz: Approx. 2 dB
BANDWIDTH 80 MHz: ≥ 3 MHz @ SWR ≤ 2.0
450 MHz: ≥ 15 MHz @ SWR ≤ 2.0
SWR ≤ 1.5 @ f.res in both bands
MAX. POWER 30 W
MECHANICAL
MATERIALS Whip:
Conical glass fibre
Chromed brass
Mount:
Chromed brass
Weather- and shockproof plastics
Stainless steel
RECOMMENDED
INSTALLATION
TORQUE
7.5 ± 1 Nm
COLOUR Black
HEIGHT Approx. 1.1 m
WEIGHT Z-version: Approx. 170 g
ZP4-version: Approx. 320 g
MOUNTING ø21 mm dia. hole
(For roof thickness 2 mm up to 7.5 mm
mounting hole should be ø22 mm dia.)
ROOF THICKNESS Max. 2.0 mm
(Models up to 7.5 mm on request)