Procom CT-27-zp4 - Manual (Page 2)

INSTALLATION
This antenna is supplied with type ZP4-mount. The whip is fastened to the
mount by means of our standard ball-joint and wing screw system. The
adjustable ball-joint ensures that the whip can always be mounted in a
vertical position independent of the angle of the installation spot.
The ZP4-mount is particularly well suited for mounting on car-roofs because
of its ability to be installed exclusively with access from the outside.
However, the antenna can be installed anywhere on the car, as the ZP4-
mount is equally well suited for mounting on e.g. trunk or wing.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
3. TUNING
The antenna should always be post-adjusted using an SWR-meter, especially
if mounted near metal parts parallel to the whip. Loosen the union nut at
the top of the coil and pull out the whip approx. 5 mm at a time until best
possible SWR is obtained. Fasten the union nut thoroughly.
PLEASE NOTE
To make this antenna operate as efficiently as possible, a matching unit has
been built into the antenna mount. Consequently, neither mount nor whip
can be used together with other mounts/whips.
PROCOM A/S reserve the right to amend specifications
without prior notice.
30/03/11