Procom MU 800-2600-lx - Manual

MU 800/2600-LX
Dual-frequency Mobile Antenna for the 800 MHz and 2600
MHz Bands
DESCRIPTION
Dual-frequency antenna – two bands – one antenna!
Stainless steel LX-mount.
Especially suited for roofmounting.
Provided with FME-connection (supplied without cable).
Bendable section in mount for adjustment of whip (tiltable 15° by hand).
Installation with access from the outside only (requiring an 18 mm dia.
hole).
ORDERING DESIGNATIONS
TYPE PRODUCT NO.
MU 800/2600-LX 130001525
SPECIFICATIONS
ELECTRICAL
MODEL MU 800/2600-LX
ANTENNA TYPE Dual-frequency mobile antenna
FREQUENCY 790 - 862 MHz and
2500 - 2690 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Vertical
GAIN Approx. 0 dB on both bands (acc. to EIA RS-329-1)
BANDWIDTH 800 MHz: > 50 MHz @ SWR ≤ 2.0
2600 MHz: > 200 MHz @ SWR ≤ 2.5 (typ.)
SWR ≤ 2.0 @ f. res.
MAX. POWER 25 W
MECHANICAL
MATERIALS Whip:
Black cover POM
Black-chromed brass
Mount:
Stainless steel
Brass
Environment-proof plastics
RECOMMENDED
INSTALLATION
TORQUE
3.5 Nm max.
CABLE FME-cable to be ordered separately
COLOUR Black
HEIGHT 93 mm
WEIGHT Approx. 33 g
MOUNTING 18 mm dia. hole
OPERATION USING A DIPLEXER
In case of operating two transceivers on one antenna at the same time, a
diplexer, type DIPX 1000/1550, is necessary to complete the system. The
tasks of the diplexer are to protect the two receiver inputs from being
destroyed by the transmitter in the contrary band and to ensure a low-loss
path between the transceiver and the antenna, which is not loaded by the
other branch. For further details please see the separate data sheet on the
DIPX 1000/1550. The diplexer fully covers both bands and, consequently,
tuning to specific frequencies is not required.
COUPLING DIAGRAM
INSTALLATION
The LX-mount is especially suited for roof-mounting. It is recommended to
mount the antenna at the centre of the roof to ensure the best
omnidirectional coverage. Mounting can take place in an 18 mm dia. hole
with access from the outside only. When cleaning the car in car-washing
machines, the whip should be removed – a 9 mm fork spanner can be used.
After wash, the whip is refitted and tightened lightly with the spanner.The
mount is equipped with a bendable section (±15°) to make it possible to
adjust the antenna to an upright position.